Bmc 5.1

A place for general BMC questions and chat
Post Reply
Sells
Posts: 5
Joined: Thu Oct 18, 2018 8:25 pm
Great Britain

Bmc 5.1

Post by Sells » Sat Oct 20, 2018 9:30 pm

Hi all new to this
I got a 10/60 with a 5.1 bmc which I required from a friend which has had a full rebuild but I have noticed it has k seal in the water
Do these have a problem with the water ways.
The engine has under taken bottom end shells con rod, piston rings and a liner as it had hydraulic lock as water passed down one cylinder throw standing

Would anyone have a manual on these engines ?
Thanks sean
Image



Rick Cobley
Senior Member
Posts: 260
Joined: Fri Mar 30, 2018 9:32 pm
Contact:
Great Britain

Re: Bmc 5.1

Post by Rick Cobley » Sun Oct 21, 2018 8:07 am

Hi, I have reproduced a couple of pages from a 5.1 manual in the data section of this forum. settings like tappets and torque settings are the same as 4 cylinder engines.

Regards Rick Cobley

Sells
Posts: 5
Joined: Thu Oct 18, 2018 8:25 pm
Great Britain

Re: Bmc 5.1

Post by Sells » Sun Oct 21, 2018 7:29 pm

Thanks rick I have seen them any more information on these engines?
Trouble shoot pages
Thanks sean

Rick Cobley
Senior Member
Posts: 260
Joined: Fri Mar 30, 2018 9:32 pm
Contact:
Great Britain

Re: Bmc 5.1

Post by Rick Cobley » Mon Oct 22, 2018 12:03 am

Hi, Apart from the pages I have reproduced the information in the 6 cylinder manual is the same as the 4 cylinder manuals.

Regards Rick Cobley

Post Reply